Autodesk HP Z800 Guia de preparacion

1 Contents Introduction ...

10 15. The monitor automatically turns off and back on, and the text “Now adjusting” is displayed in the lower left corner of the screen: 16. Aft

2 Overview of Adapter Cards The following illustration provides an overview of the adapter cards in the Z800 workstation. Note: The Mellanox InfiniB

3 1. Use the short DVI cable to connect the DVI port of the NVIDIA Quadro graphics card in slot 2 to the DVI port of the NVIDIA Quadro SDI adapter

4 Make sure to also connect the supplied DVI extender power adapter to the DVI extender cable, otherwise the monitor will not display an image. 3.

5 1. Connect the output of the sync generator to the top Ref Loop port of the AJA K3G-Box. 2. Connect the Input port of the NVIDIA SDI card (the

6 8. If not using RTD, connect SDI OUT A, SDI OUT B, SDI IN A and SDI IN B ports of the VTR to the SDI1, SDI2, SDI3 and SDI4 ports on the front of

7

8 Connecting Storage Refer to the following diagram to connect the fibre channel cables (loops) coming from your RAID controllers to

9 (CAL1, CAL2, CAL3). You may want to setup CAL1 to (native) wide-gamut mode and CAL2 to emulate a video monitor (or vice versa). A